Bi Polar ElectroWand Instructions

 Wands 700 x 300

BELIEVE IN THE MAGIC

E-Stim Systems Bipolar electrodes are designed with both of the contact points needed for electroplay in the same insertable. The BiPolar Electrowands add in an extra element of an insulated handle allowing you greater control over the position of the electrode.

Given sufficient care your electrodes should last for years, and they are covered by our Lifetime Guarantee.

 

TO USE

Before you connect any cable to the powerbox, connect the cable to the electrode,  there are 2 4mm sockets in the base of the handle, coat the electrode with conductive gel and then gently insert. The electrode is generally designed to be inserted up to the end of the ‘neck/handle join, but there are not issues if you with to insert further. The current will then flow between the head and base, stimulating the areas in-between.

Once the BiPolar ElectroWand is inserted, ensure the powerbox is switched off and the output level control is at minimum, then insert the 3.5mm jack plug into the correct socket on the powerbox.

NOTE: E-STIM ELECTRODES CANNOT BE USED WITH A CONDOM.

Switch the control box on and slowly increase the output level to provide the desired level of stimulation. For a slightly different effect you can swap the 4mm plugs over.

If you remove the ElectroWand while it is still powered the intensity of sensation may increase.

 

The ElectroWand can also be used on the surface of the skin, simply use a small about of conductive gel on the skin to 

 

SAFETY WARNING

DO NOT CONNECT ANY ELECTRICAL DEVICE TO ANY LOCATION ABOVE THE WAIST (ACROSS THE ARMS COUNTS AS ABOVE THE WAIST!), BUT ESPECIALLY DO NOT CONNECT ACROSS THE HEART, CHEST, NECK OR HEAD. DO NOT USE IF YOUR SUBJECT IS FITTED WITH A PACEMAKER OR ARE PREGNANT.

Remember you use any e-stim device at your own risk. You must read and understand the user manual and all other instructions before attempting operation.

 

CLEANING

Always clean your electrode both before and after use and make sure the electrode is completely dry before storage.

Soap, hot water and medical grade cleaning wipes can be used to clean your electrode. Do NOT use caustic cleaning substances as this may damage the electrode.

 

The BiPolar ElectroWands can be disassembled for cleaning.  When re-assembling ensure that the insulated plate  is correctly inserted onto the mounting bolt and the mounting bolt has the insulated bush fitted facing inwards. If you inadvertently loose a piece, spares are available.

 

CONNECTION AND CABLES

On the base of the ElectroWand you will find two 4mm holes. These are the connection sockets to your powerbox.

In order to connect your electrode to an E-Stim Systems Powerbox you will need a 3.5mm to 4mm cable. To insert press each of the 4mm plugs gently into the relevant socket on the electrode, to remove twist the plug anti-clockwise, and gently pull the plug, not the cable. The single 3.5mm jack plug is designed to insert into the power box. Do not leave connecting plugs inserted into the electrode during storage.

 

TO REMOVE

Switch off the control box and then unplug the cable from the Power Box.

Once the electrode is removed, clean it immediately. Make sure the electrode is completely dry before storage.