Holsters

• 

Welcome

Congratulation on purchasing a new E-Stim Systems PowerBox Holster.

 We all like to play with E-Stim, but sometimes it’s hard to find a way to keep the power box in place. So we took a few ideas and added in a bit of 3D print expertise and came up with our new powerbox holsters.

We currently have 2 styles, one created to fit the ElectroHelix, which also fits the ABox Mark 2, and the other design for the ElectroPebble, both work in the same way. The ElectroPebble version is slightly more curvy, and has a more open bottom clip. The Holster for the ElectroHelix and Box Mk2 has a solid bottom support clip.

The holsters are custom designed by us and then 3D printed in our own print farm. We are using TPU a biocompatible thermoplastic, the flexibility means it is easy to slot the power box in and retain them for normal play. The belt clip allows it to be clipped to a convenient belt or harness.

How to fit the PowerBox

Hold the Holster and Slip the PowerBox in from the top, ensuring the arms fit around the PowerBox. The top retention clip of the holster should then clip in.

The arms are semi flexible, they are not designed to bend more than 45 degrees, doing so may break them - you have been warned

Attaching

The Holster is fitted with a belt clip on the rear. Simply slip it over any convene anent waistband, belt or harness.

Adjustment

The belt clips are also adjustable - just unscrew the screw in the belt clip and re position it in the desired position and then tighten the screws.

Cleaning

You can use hand hot soapy water to clean your holsters or medical grade cleaning solutions. do not use solvents. You cannot steam sterilise or boil the holsters.