Conductive Rubber Loops
Congratulations on your purchase of a pair of E-Stim Systems Conductive Rubber Loops. These conductive rubber loops offer a comfortable and safe introduction to electro play, and are available in 2mm and 4mm Versions.
Adjustments
The conductive rubber loops are supplied with a spring loaded adjustable collar. Simply squeeze the collar to release the tension on the rubber loop, then adjust the size of the loop. Release the collar when you are happy with the fit.
Be careful when pulling on the rubber loops they will snap if excessive force is used. Try not to remove the collar completely as it is possibly to loose the small spring.
Safety
DO NOT CONNECT ANY ELECTRICAL DEVICE TO ANY LOCATION ABOVE THE WAIST. DO NOT CONNECT ACROSS THE HEART, CHEST, NECK OR HEAD. DO NOT USE IF FITTED WITH A PACEMAKER OR IF YOU ARE PREGNANT. REMEMBER YOU USE THIS DEVICE AT YOUR OWN RISK.
Cleaning
The conductive loops may be cleaned with soap and water, medical grade cleaning wipes or other cleaning materials suitable for medical instruments. Ensure the loops are clean and dry before storage.
Connection
Each conductive loop has two holes in the end of the rubber. To connect, simply push a plug of the relevant size into one loop, and the other plug into a hole on the other loop. (Not on the same loop). To remove pull the plug (not the wire) and gently twist anticlockwise. A small dab of water based lube may aid insertion and extraction.
Testing
If you are unsure as to the effect the conductive loops might have, then try them on your hand first. Ensure the loops do not touch each other.
To use
Place the loops on the penis ensuring they do not touch each other, and adjust the size so they are comfortable. Connect one plug to one loop and the other to the other loop, (as noted previously). In use the current will then flow between the two loops, stimulating the areas in-between.
Switch the control box on and slowly increase the output level to provide the desired level of stimulation.
If the subject feels discomfort then reduce the power levels.
To remove
Reduce the output levels to minimum, switch off the box and then unplug the cable from the control box. Do not remove the cables from either the control unit or the electrode whilst in operation as inadvertent electric shocks may be experienced.
