E-Bead 2.0 Electrode
Congratulations on the purchase of a Mr. S Leather E-Bead 2.0 Bipolar Electrode by E-Stim Systems. Given sufficient care your electrode will last for years, and is covered by E-Stim Systems Lifetime Guarantee*.
DESIGNED FOR YOUR PLEASURE
The E-Bead 2.0 is a collaboration between Mr. S Leather and E-Stim Systems who have brought you this amazing bipolar insertable electrode which means it is designed with both of the contact points needed for electroplay and can be used with either both fully inserted or with one in and one out of the body.
TO USE
Coat the E-Bead 2.0 with a thin layer of water-based lube and insert the first bead. The E-Bead 2.0 can be used like this or you can insert the second bead as well for a deeper sensation. The current will flow between the two beads, stimulating the areas in-between.
Once inserted, ensure the power box is switched off and the output level control is at minimum, then insert the 3.5mm jack plug into the correct socket.
NOTE: E-STIM ELECTRODES CANNOT BE USED WITH A CONDOM.
Once connected switch the control box on and slowly increase the output level to provide the desired stimulation.
SAFETY WARNING
DO NOT CONNECT ANY ELECTRICAL DEVICE TO ANY LOCATION ABOVE THE WAIST (ACROSS THE ARMS COUNTS AS ABOVE THE WAIST!), BUT ESPECIALLY DO NOT CONNECT ACROSS THE HEART, CHEST, NECK OR HEAD. DO NOT USE IF FITTED WITH A PACEMAKER, HAVE EPILEPSY OR ARE PREGNANT.
Remember you use this device at your own risk. You must read and understand this user manual and all other instructions before attempting operation.
CLEANING
Always clean your electrode both before and after use and make sure the electrode is completely dry before storage.
Soap, hot water and medical grade cleaning wipes can be used to clean your E-Bead 2.0. Do NOT use bleach or caustic cleaning substances as these may damage the E-Bead 2.0. The E-Bead 2.0 is NOT designed to be disassembled or to be immersed in liquid for cleaning.
CONNECTION
The E-Bead 2.0 is designed with a captive cable with a 3.5mm jack plug on the end which will plug in to any E-Stim Systems power boxes or any other power boxes that use a standard 3.5mm jack socket.
TO REMOVE
Reduce the output level to zero, switch off the power box and then unplug the cable from the power box. Gently pull the E-Bead 2.0 by holding the bottom bead and NOT the cable. If the E-Bead 2.0 has been fully inserted then gently use the cable to remove it until the bottom bead has come out of the body and then use the bottom bead to fully remove it.
Once the electrode is removed, clean it immediately. as previously described. Make sure the electrode is completely dry before storage.
Do not remove the cable from the power box whilst in operation as inadvertent electric shocks may be experienced.
*The Lifetime Guarantee covers the E-Bead 2.0 itself and not the cable, which is subject to a standard 3 month guarantee. Should it fail please contact us directly for advice.
