E-WMCBP 2.0 Electrode
Congratulations on the purchase of a Mr. S Leather Electric WMCBP electrode by E-Stim Systems. Given sufficient care your electrode will last for years, and is covered by E-Stim Systems Lifetime Guarantee.
DESIGNED FOR YOUR PLEASURE
The Electric WMCBP is a collaboration between Mr. S Leather and E-Stim Systems who have brought you this amazing bipolar insertable electrode. It is designed with both of the contact points needed for electroplay in the same insertable. It is fitted with a wider base to prevent deep insertion and also offers additional surface area for stimulation.
TO USE
Connect the cable to the electrode using the 4mm sockets in the base, coat the electrode with water-based lubricant and then gently insert. The electrode is designed to be inserted up to the ‘neck’, with the base outside the body, and the head inside. The current will then flow between the head and base, stimulating the areas in-between.
Once inserted, ensure the power box is switched off and the output level control is at minimum, then insert the 3.5mm jack plug into the correct socket.
NOTE: E-STIM ELECTRODES CANNOT BE USED WITH A CONDOM.
Switch the control box on and slowly increase the output level to provide the desired stimulation.
SAFETY WARNING
DO NOT CONNECT ANY ELECTRICAL DEVICE TO ANY LOCATION ABOVE THE WAIST (ACROSS THE ARMS COUNTS AS ABOVE THE WAIST!), BUT ESPECIALLY DO NOT CONNECT ACROSS THE HEART, CHEST, NECK OR HEAD. DO NOT USE IF FITTED WITH A PACEMAKER, HAVE EPILEPSY OR ARE PREGNANT.
Remember you use this device at your own risk. You must read and understand this user manual and all other instructions before attempting operation.
CLEANING
Always clean your electrode both before and after use and make sure the electrode is completely dry before storage.
Soap, hot water and medical grade cleaning wipes can be used to clean your electrode. Do NOT use bleach or caustic cleaning substances as this may damage the electrode. It is possible to disassemble your electrode for cleaning. When re-assembling ensure that the insulated neck is correctly inserted onto the mounting bolt and the mounting bolt has the insulated bush fitted facing inwards. If you inadvertently loose a piece, spares are available.
CONNECTION & CABLES
On the base of the electrode you will find two 4mm sockets.(One on the side of the base and one underneath). These are the connections to your power box.
In order to connect your electrode to an Power box you will need a suitable cable with 4mm connectors. To insert press each of the 4mm plugs gently into the relevant socket on the electrode, to remove twist the plug anti-clockwise, and gently pull the plug, not the cable. Do not leave connecting plugs inserted into the electrode during storage.
TO REMOVE
Switch off the control box and then unplug the cable from the Power Box.
Once the electrode is removed, clean it immediately. Make sure the electrode is completely dry before storage.
