ElectroRing Size Set
Choosing the right size ElectroRing can be hard, so we have created a full set of sizing rings ,created so you can decide what size ring or rings you need.
How to Use
To use a set of e-stim sizing rings for the penis when fully erect, begin by ensuring you're in a private, relaxed setting. You do not need an e-stim device during this process, These rings are only for sizing, not for active use.
Run your finger around the inside of the sizing ring before use and check for any nicks or scratches.
Wait until your penis is fully erect. This is important because the ElectroRing ring needs to fit correctly during arousal, which is when e-stim is typically applied. Once erect, select a ring that looks like it might fit comfortably. Gently slide the ring down the shaft. It should go on with slight resistance but without any force or discomfort.
The right size should feel snug around the penis without causing pain, pressure, or a throbbing sensation. The ring should not be distorted. You should be able to wear it for a few minutes while erect, with no tingling, discolouration, or numbness. If any of these signs appear, remove the ring immediately and try a larger size.
If the ring feels too tight or difficult to remove, choose the next size up. If it slides on too easily or moves around, go down one size. Test a few nearby sizes until you find one that stays in place without cutting off circulation or causing discomfort.
Once you find the size that fits well during a full erection, write it down.
Only use the properly sized ring with your e-stim device, and follow all safety instructions included with the equipment.
After Use
The sizing rings are not designed for multiple uses, but if you wish to re use them, then clean all the rings thoroughly with warm water and mild soap, then dry them completely before storing. It is NOT possible to sterilise the rings.
